dwmmc@fe2b0000: 1, dwmmc@fe2c0000: 2, sdhci@fe310000: 0
Bootdev(atags): mmc 0
MMC0: HS200, 200Mhz
PartType: EFI
DM: v1
No misc partition
boot mode: None
FIT: No boot partition
** File not found /extlinux/toybrick.dtb **
Found DTB in resource part
DTB: rk-kernel.dtb
HASH(c): OK
I2c0 speed: 100000Hz
vsel-gpios- not found! Error: -2
vdd_cpu init 900000 uV
PMIC: RK8090 (on=0x40, off=0x00)
vdd_logic init 900000 uV
vdd_gpu init 900000 uV
vdd_npu init 900000 uV
io-domain: OK
get vp0 plane mask:0x22, primary id:5, cursor_plane:-1, from dts
get vp1 plane mask:0x15, primary id:4, cursor_plane:-1, from dts
get vp2 plane mask:0x8, primary id:3, cursor_plane:-1, from dts
Could not find baseparameter partition
Model: rockchip,rk3568
Rockchip UBOOT DRM driver version: v1.0.1
vp0 have layer nr:2[1 5 ], primary plane: 5
vp1 have layer nr:3[0 2 4 ], primary plane: 4
vp2 have layer nr:1[3 ], primary plane: 3
Using display timing dts
edp@fe0c0000: detailed mode clock 153000 kHz, flags[a]
H: 1920 2090 2100 2250
V: 1080 1100 1102 1132
bus_format: 100e
VOP update mode to: 1920x1080p0, type: eDP0 for VP1
VOP VP1 enable Smart0[1080x1080->1080x1080@420x0] fmt[1] addr[0xee257000]
Link Training success!
final link rate = 0x0a, lane count = 0x02
hdmi@fe0a0000 disconnected
CLK: (sync kernel. arm: enter 816000 KHz, init 816000 KHz, kernel 0N/A)
apll 1416000 KHz
dpll 780000 KHz
gpll 1188000 KHz
cpll 1000000 KHz
npll 1200000 KHz
vpll 612000 KHz
hpll 24000 KHz
ppll 200000 KHz
armclk 1416000 KHz
aclk_bus 150000 KHz
pclk_bus 100000 KHz
aclk_top_high 500000 KHz
aclk_top_low 400000 KHz
hclk_top 150000 KHz
pclk_top 100000 KHz
aclk_perimid 300000 KHz
hclk_perimid 150000 KHz
pclk_pmu 100000 KHz
No misc partition
Net: eth0: ethernet@fe2a0000
Hit key to stop autoboot('CTRL+C'): 0
Could not find misc partition
ANDROID: reboot reason: "(none)"
optee api revision: 2.0
TEEC: Waring: Could not find security partition
Not AVB images, AVB skip
android_image_load_by_partname: Can't find part: boot
Android image load failed
Android boot failed, error -1.
## Booting FIT Image FIT: No boot partition
FIT: No fit blob
FIT: No FIT image
Could not find misc partition
Could not find userdata part
MMC error: The cmd index is 1, ret is -110.....
Card did not respond to voltage select!
mmc_init: -95, time 12
switch to partitions #0, OK
mmc0(part 0) is current device
Scanning mmc 0:3...
Found /extlinux/extlinux.conf
Retrieving file: /extlinux/extlinux.conf
215 bytes read in 3 ms (69.3 KiB/s)
1: rockchip-kernel-5.10
Cannot find ohos misc partition
Load from partition ' ramdisk ' to address 0xa200000, count: 8192 block(s)
Read from partition ' ramdisk ' done, total block(s) 8192
Openharmony ramdisk_addr_r = 0x0a200000:0x400000
Retrieving file: /extlinux/Image
47534088 bytes read in 267 ms (169.8 MiB/s)
append: earlycon=uart8250,mmio32,0xfe660000 root=PARTUUID=614e0000-0000-4b53-8000-1d28000054a9 rw rootwait rootfstype=ext4
Retrieving file: /extlinux/rk3568_edp_1920x1080.dtb
165516 bytes read in 5 ms (31.6 MiB/s)
Fdt Ramdisk skip relocation
No misc partition
## Flattened Device Tree blob at 0x0a100000
Booting using the fdt blob at 0x0a100000
'reserved-memory' ramoops@110000: addr=110000 size=f0000
Using Device Tree in place at 000000000a100000, end 000000000a12b68b
Adding bank: 0x00200000 - 0x08400000 (size: 0x08200000)
Adding bank: 0x09400000 - 0xf0000000 (size: 0xe6c00000)
Adding bank: 0x1f0000000 - 0x200000000 (size: 0x10000000)
Total: 1069.946 ms